What the calculations do not cover
The site computes the geometry of motion of ideal rigid links in a plane. It does not say whether a real mechanism will carry a load, last, or be safe. Use the numbers to understand and compare designs, and check a real design with methods that include forces, materials and tolerances.
Physics that is not modelled
- Forces only as input-to-output ratios. Under frictionless, slow-motion assumptions, the torque or force the input needs for a given output load is found by virtual work, and nothing more. Gravity, friction, inertia, springs, impacts and the forces in joints and pins are not computed.
- No strength or stiffness. Links do not bend, stretch or break; stresses and fatigue are not estimated.
- Ideal joints. Pins and sliders have no clearance, backlash, wear or friction.
- No thickness. Links are lines and joints are points, so links can pass through each other in a drawing. A real build may collide; check clearances yourself.
- Planar only. Every part moves in one plane. Spatial (3D) linkages are not covered.
Rules of thumb shown on the pages
Some pages mention design guidelines, such as keeping the transmission angle above about 40°. These are common rules of thumb about forces; the site shows the angle, but does not compute whether a particular value is acceptable for your load.
Numerical limits
- Near a dead point, where two links line up, positions are known only to about 1.5 × 10−8 of a link length and speeds grow without bound. There the engine reports the pose as singular and gives no speeds or accelerations.
- Values larger than 109, or lengths that differ by more than a factor of 106, are refused because they are outside the range the engine is tested for.
- Positions are sampled at a finite number of input values (for example every degree); tables show selected rows of these samples.
Path synthesis
- It is a search, not a proof: "not found" does not mean that no linkage exists, and the best candidate is the best found, not the best possible.
- Only four-bars driven by a fully turning crank are searched. Rocking inputs and paths that go back and forth along the same line are not.
- It matches the shape of a path, not the timing along it.
- A four-bar's path is smooth, so sharp corners can only be approximated; the measured error says by how much.
- For an open path, the rest of the motion is not constrained, so check it against obstacles.
- Paths are limited to 5,000 points.
The details are on the path-synthesis page; how the numbers themselves are produced is on the methodology page.
Units
Lengths are shown in millimetres and angles in degrees unless stated. Because kinematics does not depend on scale, any length unit gives the same angles and the same shapes; only the labels change.